J4 ›› 2018, Vol. 35 ›› Issue (1): 79-85.

• 激光应用 • 上一篇    下一篇

温度对电子辐照下聚酰亚胺表面充电的影响

蒙志成,孙永卫,原青云,王松,刘浩,周立栋   

  1. 军械工程学院
  • 收稿日期:2016-11-28 修回日期:2017-01-04 出版日期:2018-01-28 发布日期:2018-04-04
  • 通讯作者: 蒙志成

Effect of Temperature on Surface Charge of Polyimide under Electronic Irradiation

  • Received:2016-11-28 Revised:2017-01-04 Published:2018-01-28 Online:2018-04-04

摘要: 航天器运行于温度变化的空间环境中时,其表面介质材料会造成不同程度的充电,容易引起放电隐患。为了研究温度变化和等离子体环境变化对航天器表面介质材料充电水平的影响,利用本单位自行研制与搭建的温度可控的航天器介质材料表面带电综合实验系统,对聚酰亚胺材料进行表面充电实验。实验结果表明:温度不变的情况下,随着束流密度的增大,聚酰亚胺表面充电平衡电位逐渐增大。束流密度不变的情况下,随着温度的升高,聚酰亚胺表面充电平衡电位逐渐减小。温度在243K~363K范围内时,束流密度越大,温度变化对聚酰亚胺表面充电平衡电位的影响越小。温度在243K~273K范围内时,束流密度越大,温度变化对聚酰亚胺表面充电平衡电位的影响越大。

关键词: 束流密度

Abstract: When the spacecraft is operating in the space environment of temperature change, its surface dielectric material will be caused different levels of charge, the discharge hazards are easily caused. In order to study the influence of temperature change and plasma environment change on the charging level of surface dielectric materials, the surface charge synthetic experimental system for the dielectric material of spacecraft, which was developed and established by own, and temperature controllable, was used to experiment the surface charge of polyimide material. Experimental results show that, under the condition of constant temperature, with the increase of beam current density, the balance potential of surface charge of polyimide is gradually increased. Under the condition of constant beam density, with the increase of temperature, the balance potential of surface charge of polyimide is gradually decreased. When the temperature is in the range of 243K~363K, the greater the density of the beam, the smaller the effect of the temperature change on the surface charge balance potential of the polyimide; when the temperature is in the range of 243K~273K, the greater the density of the beam, the greater the effect of the temperature change on the surface charge balance potential of the polyimide.

Key words: Beam density

中图分类号: